Form tie rods DG 15/17 made from mild steel and steel EN 8 are threaded along their entire length. Natural finish with anti rust coating. Core diameter = 15mm (outer diameter= 17mm). Weight 1.44 Kg/m
Plates are made from steel ST 37 to accommodate tie rods DG 15/17.
To be used with wing nuts or hexagon nuts.
For use in both timber and steel formwork.
This malleable cast iron - Grade BM 30- 06 Grey iron part is used together with tie rods DG 15/17 for the construction of watertight concrete walls. It is very often the case that customers demand the tie rods to be connected up to a so-called waterstop in the middle of the wall.
UNIPRO WaterStop is a specially formulated Polyvinyl Chloride (PVC) compound. Flexible, resilient, tough, chemically inert, is not affected by weathering, low temperatures, or constant immersion in water. It will withstand rough treatment during installation, yet is relatively easy to install and splice.
Extruded polystyrene rigid foam with skin, colored blue throughout, according to ASTM standard C 578-95, as manufactured by Oriental Polystyrene (OriFoam). Material thickness should be as indicated in the drawing and have many good properties.
EEI Expanded Polystyrene is rigid and light - weighted. By controlling the density of expanding beads during the manufacturing process, EEI can custom produce insulation materials according to the specific requirements of customers
EPOLY BOARD is extremely strong in puncture and injury resistance. It is engineered to resist puncture at over 1100, 1300, 1500, 2000, 24000 and 2600 Newton as per ASTM E-154.
POLY BOARD differs from any other materials used to protect the waterproofing membrane as it enjoys flexibility
which enables its use for tacking corners, protrusions, rounded surfaces and also uneven surfaces.
UNITECH Filler Boards is manufactured from highly resilient softwood fibers coated with bitumen. Filler Boards are dry and clean, and cannot extrude any form of staining matter. They are resistant to moisture penetration and ice formation in the joint. They are immune to dry and wet rot, fungus and most forms of insect attack or similar forms of deterioration.
Semi rigid expanded insulation cork boards are naturally dark in color and although designed for insulation purposes they do have multifunctional uses. The cork’s low thermal conductivity offers a high energy efficiency, thus contributing for an environmental and economic saving.
Poliane is a polyethylene vapour barrier to alkalis, salts, acids and chemicals found in sub-soils.
Fully stable and waterproof.
Used as a vapour barrier and damp proof membrane in concrete slabs, floors, insulation boards shuttering , etc... For corrosion protection of water and oil pipelines. Protects from the sun, wind, rain, dust and damage.
A natural choice in designing, building and constructing works including roads and highways; ground, drainage and filtration systems; hydraulic works, waste disposal sites and water purifying plants. Geotextile has been defined as - A permeable geosynthetic comprised solely of textiles.
The Effisus E coroof System is a complete, ecient, and sustainable system that guarantees a roof’s energy-ecient sealing and protects a building where it is most vulnerable and exposed to atmospheric conditions, increasing its overall "robustness".
The Ellisus Roofyard system not only transforms your roof into a garden but is also a complete, efficient, and sustainable system for living roofs. Merge your building with nature and make your urban environment a more welcoming space! Effisus Roofyard guarantees a roof's waterproofing and maximises the roof's (and the building's).
UNIPRO Rockwool Blanket conforming to ASTM C-553 and ASTM C-665 is a lightly bonded insulating material available with or without facing. These products can be faced on one side or both sides to form a firm but flexible multi-purpose insulating materials.
Poly TI is a high performance one part Polyurethane sealant weather-resistant, non-sagging, and water tight with excellent adhesion properties designed for use in all types of joints, vertically and horizontally. Poly TI has a movement capability of ±25% of the joint width, making it ideal for joints.
MARISEAL® 260 is a premium, liquid-applied, highly permanent elastic, cold applied and cold curing, one component polyurethane membrane used for long-lasting waterproofing.
The MARISEAL® 250 is the backbone of the MARISEAL® SYSTEM functioning as the main elastic and waterproofing membrane of the system.
The MARISEAL® 250 is a one-component, liquid-applied, cold applied and cold curing, polyurethane coating that cures to a seamless, highly permanent elastic waterproofing membrane.
The MARISEAL® 400 is a pigmented, color- and UV-stable, highly permanent elastic, cold applied and cold
curing, one component aliphatic polyurethane coating,
used as a top-coat for protection over exposed,
polyurethane waterproofing coatings.
MARISEAL® 600 is a fast-curing, liquid-applied, highly
permanent elastic, cold applied and cold curing,
bitumen extended, two component polyurethane
membrane used for long-lasting waterproofing.
UNIPRO Closed-Cell Backer-Rod is a closed-cell, polyethylene
foam joint filler and backing for elastomeric sealants.
Its resilience accommodates dynamic joints.
Eagle Mastic (2-components polyester) is a synthetic resin-based adhesive with a specific weight between 1.1 and 1.65 gram/cm3.
Almost all types of tiles, such as ceramic wall and floor tiles, terrazzo, quarry/sand stones and marbles can be affixed using UNIFIX 401 Tile Fix
Unigrout 201 is a cement-based, polymer-modified tile grout mortar, for filling grout joints of ceramic wall and floor tile, porcelain tile, and mosaic tile, for walls and floors
Eagle Seal Silicone.
Medium modulus acetoxy silicone sealant.
This sealant is ready to use. After suitable joint preparation and masking, the sealant is gunned into place and tooled within 5 minutes, using a spatula which has been dipped in a soapy water.
Eagle Seal Silicone.
The PROJOLLY SQUARE, available in 18 colors with EAN BAR CODE, facilitates installation, eliminating the fragile ceramic trim. it is used for outside corners of tiles to complete the finish of wall coverings, decking, steps, bathtubs,
etc. Impeccable, precise work is ensured with a superior aesthetic effect.
NAMCODUCT® conduit pipes and fittings meet the requirements prescribed by the following standards organisations:
SASO, BS, NEMA and ASTM. Our PVC pipe conduit range in straight runs of 2.9, 3, 6 meters are marked with standards specificatio requirements
NThe standard cable ties are produced exclusively in Polyamide 6.6 to avoid problems with separation of material (e.g., metals) during recycling or interference with electronic equipment. The black cable ties are added with carbon black that gives an UV resistance for outside applications.
EV 100 is a thin wall heat shrinkable tubing in cross-linked polyolefin, economic, suitable for electrical insulation and general applications where a low shrinking temperature is required.
Available in reel, dispenser box, 1 mtr. length.
Plasterboards are the smart modern substitute for the traditional cement/brick walls. It possesses various advantages through the ability to save space by creating thinner walls, while offering a higher rate of noise cancellation and fire resistance, it is also faster and cheaper to install.
Magnesium oxide boards are used in place of traditional gypsum drywall as wall and ceiling covering material and sheathing. It is also used in a number of other construction applications
Fiber cement boards have taken the international market by storm. The strong portfolio of advantages
make the product widely endorsed and appreciated by architects and customers worldwide
SFSP provides a complete product range of steel accessories for Cement and Magnesium Oxide Boards. SFSP Studs, Runners, Furring Channels, Ceiling Channels, and wall Angles are among the range of products produced according to relevant standards for the installation of Cement and Magnesium Oxide boards.
Lead is generally the most cost-effective radiation shielding material that protects against the effects of gamma rays and x-rays. The properties of lead shielding which makes it an excellent shielding material is its density, high atomic number.
Crepe Paper coated with Cured natural rubber adhesive. Ideal use for auto painting, outdoor painting, masking, packing, marking, bundling, splicing and general applications.
Also known as Drywall Joint Tape is made from woven fiber to create a strong drywall joint. Ideal for Joint finishing and patching.
Single Component, moisture curing PU Foam. Mainly used for sealing and insulation, filling of joints and cavities.
ASMACO GOLD B2 FIRE RETATDANT with CFC Free propellants is a Single Component, moisture curing PU Foam. Excellent Fire Retardant properties Mainly used for sealing and insulation, filling of joints and cavities.
ASMACO 2500 is a single component acetic cure silicone sealant which vulcanizes on exposure to moisture in the air at room temperature, to produce a flexible elastomeric sealant. It is suitable for all common construction and glazing application.
PE-coated cloth Tape with a pressure sensitive rubber adhesive coating combined to provide a quality product. It is a good choice for bundling, heavy carton packing, general maintenance, pipe wrapping, carpet fixing, air-conditioning ducts seam and joint sealing etc.
High Temp Paint has a very good thermal resistance ranging from 400° - 600°C. The paint contains silicon resin along with high quality pigment. Most suitable for chimney, barbecues, engines and motorcycles, furnace, stove oven etc
The durability and life of the chute depend on the quality of the plastic. Superchute® uses a high grade polyethlyene that is extremely resistant to abrasion and temperature extremes.
Aveho Odor Removal Technology is an engineered material consisting of micro-sized particles that capture and physically bind odor-causing compounds, or catalytically convert the odor molecules into non-odorous molecules.
Airocide® Photocatalytic Air Purification System; developed to oxidize all airborne organic matter, even
those too small to be filtered.
Gentoo is the next generation of corrosion-resistant and easy-cleaning coatings. With its combination of high performing abrasion resistance and very low sliding angle, Gentoo excels where other coatings have fallen short.
- 40 QT/38L cooler holds 48 cans or 28 12 oz. bottles - Advanced insulation technology keeps ice frozen up to 3 days - Wheeled design with long, telescoping handle for easy transport - Hinged lid with built-in weather resistant storage area for iPads and tablets - Weather sealed storage and charging area for cell phones and digital music players
The crumb rubber has an output of 4 grades, and can be made into any shape or colour depending on its use and application.
1. 5 – 10 Mesh Size (4 – 2 mm)
2. 10 – 14 Mesh Size (2 – 1.4 mm)
3. 14 – 30 Mesh Size (1.4 – 0.5 mm)
4. Minus 30 Mesh Size (0.5 mm)
We are committed to delivering maximum value to our clients helping them succeed in a constantly changing and challenging world.
© 2017 Unipro . All rights reserved | Designed and Developed by